jbyrd24
Member
Hi all.
Never thought I'd have to post this.
I have been using a Hut Pen Drilling Jig
when drilling my blanks. I can start in the dead center
and end up quite a bit out of center on the other side.
I drill slowly and clean the bit as I go. Would a pilot
hole help or is there simply something I'm doing wrong.
I attempted to turn a tapered pen yesterday and by the time
I got to the small end the blank blew. Any help would be
greatly appreciated.
Thanks
Bryan
Never thought I'd have to post this.
I have been using a Hut Pen Drilling Jig
when drilling my blanks. I can start in the dead center
and end up quite a bit out of center on the other side.
I drill slowly and clean the bit as I go. Would a pilot
hole help or is there simply something I'm doing wrong.
I attempted to turn a tapered pen yesterday and by the time
I got to the small end the blank blew. Any help would be
greatly appreciated.
Thanks
Bryan