ericatcraft
Member
This is a general announcement about our Junior series of pen kits, I wasn't sure where to post it so if anyone thinks I should post it somewhere else on the forums please let me know. I just want to make sure that everyone has a chance to see it.
We now have in stock 10.5mm drill bits for use with the Jr. Gentlemen’s, Jr. Statesman, and Jr. Emperor pen kits. This bit is meant to replace the current recommended bit of 27/64â€. We have found the 10.5mm to be a slightly better fit for the smaller of the two brass tubes. If you purchased a 27/64†bit from Craft Supplies USA for the Jr. Gentlemen’s, Jr. Statesman, or Jr. Emperor pen kit and are not satisfied with it, please contact our customer service team and they will gladly send you a replacement 10.5mm bit at no charge. You can reach us anytime between 7:00 AM and 6:00 PM (Mountain standard time) at 1-800-551-8876. The part number for the 10.5mm bit is 251-1050. If you do not need a replacement 10.5mm bit but would like to purchase one the cost is $5.99 each.
Thank you to everyone who contributed their thoughts regarding this drill bit, we appreciate all of your feedback and hope that this new bit makes your turning a little easier!
We now have in stock 10.5mm drill bits for use with the Jr. Gentlemen’s, Jr. Statesman, and Jr. Emperor pen kits. This bit is meant to replace the current recommended bit of 27/64â€. We have found the 10.5mm to be a slightly better fit for the smaller of the two brass tubes. If you purchased a 27/64†bit from Craft Supplies USA for the Jr. Gentlemen’s, Jr. Statesman, or Jr. Emperor pen kit and are not satisfied with it, please contact our customer service team and they will gladly send you a replacement 10.5mm bit at no charge. You can reach us anytime between 7:00 AM and 6:00 PM (Mountain standard time) at 1-800-551-8876. The part number for the 10.5mm bit is 251-1050. If you do not need a replacement 10.5mm bit but would like to purchase one the cost is $5.99 each.
Thank you to everyone who contributed their thoughts regarding this drill bit, we appreciate all of your feedback and hope that this new bit makes your turning a little easier!