Diameter ?

[rjwolfe3]

Does anyone have the diameters of the bushings used to turn slimlines between centers? I am going to try that route and I am going to try to make the bushings from corian since I can't seem to buy them.

 

[sbell111]

Toss a caliper onto one of your slimline kits' 'middles' (or tip or cap). That's the size.

 

[rjwolfe3]

I was hoping to get the actual size of the bushing that Johnnycnc makes since my slimline kits are different sizes based on where I buy them from. And I need the size that goes inside the blank so that I can turn without a mandrel.

 

[rjwolfe3]

Wow I was hoping someone had picked up a set of these bushings. I guess I will stick with the mandrel for now. Thanks.

 

[Blind_Squirrel]

.246 and .331

 

[rjwolfe3]

Scott you are da man! Thank you so much and I apologize for being impatient.