I recently purchased a Delta 12" Disc Sander to help with squaring the ends of pen blanks and rounding off sharp corners.
Here is my setup:
The problem - and you can even see it in the photo - the miter gauge sits proud of the surface... so it wobbles forward and backward on that axis. If you hold it right, everything is square.. but it really wants to wobble.
Any suggestions on solving this problem?
Either way, I'm already in love with trimming the ends this way. So much gentler than the barrel trimmer in the drill.
Thanks
Here is my setup:
The problem - and you can even see it in the photo - the miter gauge sits proud of the surface... so it wobbles forward and backward on that axis. If you hold it right, everything is square.. but it really wants to wobble.
Any suggestions on solving this problem?
Either way, I'm already in love with trimming the ends this way. So much gentler than the barrel trimmer in the drill.
Thanks