Blue Danube
Member
- Joined
- Jul 18, 2010
- Messages
- 22
Good Afternoon,
I just obtained a nice piece of figured Hard Maple for pen blanks.
I would like to cut some at an angle other than ninety degrees from grain flow.
Any suggestions for showing off grain? Ten degree? Fifteen degrees?
Not a probelm to cut I have a compound mitre saw to work with
Thanks for your replies and help!!
I just obtained a nice piece of figured Hard Maple for pen blanks.
I would like to cut some at an angle other than ninety degrees from grain flow.
Any suggestions for showing off grain? Ten degree? Fifteen degrees?
Not a probelm to cut I have a compound mitre saw to work with
Thanks for your replies and help!!