G1Pens
Member
When drilling a lucite blank today it cracked as the bit was exiting the blank. The crack runs about 1/3 up the blank.
My question is....Is it worth trying to turn this? Is the crack going to be so noticable that even if it doesn't blow up that it is not going to look good?
I kinda hate to take the time to glue in the tube and even try turning if it is not going to look right.
My question is....Is it worth trying to turn this? Is the crack going to be so noticable that even if it doesn't blow up that it is not going to look good?
I kinda hate to take the time to glue in the tube and even try turning if it is not going to look right.