bitshird
Member
Here is a rendering of a clip that I think I'll try, I believe it will have enough tinsel strength to keep from bending the way the outer edged are filleted and the center is crowned I think there will be about a 4% to 7% shrinkage rate, I wonder what opinions are on the ball on the tip, could it just be on the bottom and allow the natural edges to continue on the top surface since it goes to a taper any way, and just keep the ball or half hemisphere on the bottom , or bust a plain half round,
I'm not fishing for a market, I'm not advertising, nor doing market research or testing the waters, just looking for suggestions since this part has proven to be the biggest buggaboo on making kitless pens.
Jeff if you feel this post is in error please remove it.
I'll set up a piece of wax and get it in the mill, after I get some suggestions,
I'm not fishing for a market, I'm not advertising, nor doing market research or testing the waters, just looking for suggestions since this part has proven to be the biggest buggaboo on making kitless pens.
Jeff if you feel this post is in error please remove it.
I'll set up a piece of wax and get it in the mill, after I get some suggestions,