ed4copies
Local Chapter Manager
If any of you make this pen, I am looking for "feedback", please.
Someone has told me they can't get the "transmission tube" to press into the "finial adapter" far enough.
The instructions say "The tube should stick out about 9/16" from the finial adaptor". 9/16"=.5625" (for reference, the piece is .89" in length, to start)
I have made a couple of these--one I did this morning--the piece stuck out .6". While this worried me, I completed the pen and it works GREAT. Pen tip looks good---no problems.
So, I am looking for feedback on this kit.
I KNOW if you don't make a block with a hole in it to press fit the "click" mechanism, you WILL screw up the transmission. But, if this block IS used, is there any other way to mess up the final pen???
Thanks for ALL feedback---BAD, GOOD and in-between!!!
Someone has told me they can't get the "transmission tube" to press into the "finial adapter" far enough.
The instructions say "The tube should stick out about 9/16" from the finial adaptor". 9/16"=.5625" (for reference, the piece is .89" in length, to start)
I have made a couple of these--one I did this morning--the piece stuck out .6". While this worried me, I completed the pen and it works GREAT. Pen tip looks good---no problems.
So, I am looking for feedback on this kit.
I KNOW if you don't make a block with a hole in it to press fit the "click" mechanism, you WILL screw up the transmission. But, if this block IS used, is there any other way to mess up the final pen???
Thanks for ALL feedback---BAD, GOOD and in-between!!!
Last edited: