fernhills
Member
Hi, this is a Italian lucite,color is deeper in real life.. Carl
Hi every one and thanks for your reply..Tanner,i didn`t paint the tubes in this one,i held the drilled blank up to a bright light and slipped the tube in and i didn`t see anything so i went ahead in did the pen ....The blanks i got from the PEN WORKS,PENCHETTA on this site,I visit thier web page often and admire thier work.. Thanks CarloOriginally posted by penmanruss
Very nice, like the look: is that the lucite available from pipemakers supply? I have been of two minds as to whether to try their products or not. Thanks[^]
Hi,it was just like acylic to turn,it got down to round real fast with my gouge,had to shapen my skew a couple of times as i was turning down to bushings,those wet shapeners are nice for that, real quick.I don`t know if it was me but it looked like it was smoking while i was turning down to size,so o backed off a little and went slower.It shines up real nice with MM.. CarlOriginally posted by simomatra
Very nice and a timely thread as I just received my first supply of lucite rod. Any pointer on turning and finishing?
Originally posted by fernhills
Hi every one and thanks for your reply..Tanner,i didn`t paint the tubes in this one,i held the drilled blank up to a bright light and slipped the tube in and i didn`t see anything so i went ahead in did the pen ....The blanks i got from the PEN WORKS,PENCHETTA on this site,I visit thier web page often and admire thier work.. Thanks CarloOriginally posted by penmanruss
Very nice, like the look: is that the lucite available from pipemakers supply? I have been of two minds as to whether to try their products or not. Thanks[^]