Cody, it seems everyone has CBN wheels these days. I don't know if anyone's wheels are better than one from another vendor. I guess many come from the same factories.
I believe our woodturning club did a group buy on the Hurricane wheels a few years back. I have not heard any negative feed back on them.....nor exceptional praise either.
Here is another source for you to check out.
https://woodturnerswonders.com/
Ken has all kinds of wheels and grinders too, package deals, lights, etc. check out his videos on his site.
Personally, I go with a flat wheel (no radiused edges). This gives me more usable grinding surface. Also, most CBN wheels now have some grit on the flat edge/side of the wheel which is good for putting a flat or convex going on a skew for example.
I am using one 180G CBN wheel and one original 60G stone wheel which came on the grinder. The stone wheel for shaping a chisel and the CBN for the finish grind, touching up. The stone wheel is better at creating a burr on my scrapers than the CBN.
I also use a diamond hone to maintain an edge between grindings.
Good luck!