Ray1955
Member
I put my bushings on the mandrill and inserted my blank and applied a
SHELL WAX and over the top used a CA Thick adhesive since I had no thing.
Well.....I put the thick on and it didn't even buff out nicely.
Worst part was trying to get the end bushing off.
I saw on line you can use an ACETONE.....wife had fingernail polish remover.
I used it liberally.......I wanted to get this off didn't want to ruin an expensive Mandrell.
Then I used a utility knife between the blank and the bushing and went all the way around........still no luck.
took small pair of vice grips, set mandrill on end and hit the vice grips in downward motion to see if I could break it loose and it worked.
I WILL NEVER DO THIS AGAIN.
Ray
SHELL WAX and over the top used a CA Thick adhesive since I had no thing.
Well.....I put the thick on and it didn't even buff out nicely.
Worst part was trying to get the end bushing off.
I saw on line you can use an ACETONE.....wife had fingernail polish remover.
I used it liberally.......I wanted to get this off didn't want to ruin an expensive Mandrell.
Then I used a utility knife between the blank and the bushing and went all the way around........still no luck.
took small pair of vice grips, set mandrill on end and hit the vice grips in downward motion to see if I could break it loose and it worked.
I WILL NEVER DO THIS AGAIN.
Ray