Queso
Member
I bought some Baron kits from BB last week, but I just realized I don't have a pen mill adaptor to fit the tubes. Does Woodcraft sell one to fit their Navigator pen?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Baron/Navigator Pen mill adaptor
- Thread starter Queso
- Start date
Signed-In Members Don't See This Ad
See more from Queso
- Status
- Not open for further replies.
Just make you own like I did from a piece of corian... drill it out with a .25 bit and then turn it to the proper diameter of the tubes.. a whole lot cheaper and easier in the end... besides it is good practice...
Fleabit
Member
Yup...did the same thing with a scrape of wood. Just drilled it for a 7mm tube and than turned it down to fit the baron tubes.
- Status
- Not open for further replies.