mdl7070
Member
Here are a few pics of a screw up and a try at a save.
While i was preparing my blanks i was useing my pen mill
And didnt relize the brass tube had come loose in the blank
And pushed out the other end.
So once i got the tube back in i took my cut off piece and
The pattern just didnt match up and still doesnt.
I took a piece of a red bull can and did a segment with it
Then turned it. It was my first try segmenting with a soda
Can.
Not the best of pics but iam sitting in the semi useing my phone.
While i was preparing my blanks i was useing my pen mill
And didnt relize the brass tube had come loose in the blank
And pushed out the other end.
So once i got the tube back in i took my cut off piece and
The pattern just didnt match up and still doesnt.
I took a piece of a red bull can and did a segment with it
Then turned it. It was my first try segmenting with a soda
Can.
Not the best of pics but iam sitting in the semi useing my phone.
Attachments
Last edited: