2M Drill Chuck

Signed-In Members Don't See This Ad
Rockytime

Rockytime

Member
Joined
Jun 3, 2014
Messages
1,074
Location
Arvada, CO 80003
I am in need of a M2 drill chuck for my lathe. I need the taper threaded for a draw bar. I have drill chucks but they all have a tang. I have seen vendors on this list that sell them but I don't recall who they are. PSI has drill chucks but they do not say if they are for draw bars or not. I can look on MSC or Emco but I would prefer to purchase from a IAP member.
 
You must log in or register to reply here.
Previous Next
Top Bottom