opfoto
Member
So I fnally got my live center on the lathe.....then my bushing....then my glued up blank then bushing then dead center....The blank met the chisel the rough went round and round.....finally when I approached the diameter I was hoping to sneak up on I noticed that The tail stock of the black was turning less than true!!!! Really... did my eyes go buggy...???
I know I used the mill to show the shiney brass after I glued them up....the bushings pop out as described by JohnnyCNC
I know I locked down the tailstock prior to turning....I know I twisted the dead center in as I mounted it....
I know I did not over extend the quill....
Where did I go wrong.....this wasn't supposed to happen.....
Murphy....MURPHY was that you???
I know I used the mill to show the shiney brass after I glued them up....the bushings pop out as described by JohnnyCNC
I know I locked down the tailstock prior to turning....I know I twisted the dead center in as I mounted it....
I know I did not over extend the quill....
Where did I go wrong.....this wasn't supposed to happen.....
Murphy....MURPHY was that you???