If I wanted to oreder collets for a Beall collet chuck from some where else what collet type is it. I though I had seen this info before but can not find it.
HGere's a link where it was mentioned.
It is an er-32.
When you try a search always check archived posts.
It is a very rare occurance when I can't find something I am looking for on this for, Thanks Jeff!
http://www.penturners.org/forum/topic.asp?ARCHIVE=true&TOPIC_ID=1983&SearchTerms=Beall,collet
They are ER-32, here is a source for them:
http://www.hhip.com/
Pretty much all suppliers for machine shops have them, some cost more, some less. I got mine from Travers, but only since H+H was out of the size I needed.