BeeAMaker
Member
Not sure where to put this post, but since I will be asking for some feedback, I figured this would be the spot.
A lot of you have ordered my Pressure Pot Caddy or the Pressure Pot Caddy V2 and have time to use it for a while. I was hoping I could get some feed back on it from those that have used it.
Just some questions off the top of my head,
1. How do you like it?
2. What happen to it if you had a resin spill?
3. Value for the money?
4. Too many holes in the V2?
5. Any other suggestions you can make or issues you have had with it.
I am also looking at making a version out of HDPE 1/4" sheet. This would be so resins hopefully peel right off. However it would make the Caddy more expensive, about $35 each (V2 version) Would it be worth it?
It's been a while since I have been able to turn, so hopefully again soon!
Thanks for any feedback!
:biggrin:
A lot of you have ordered my Pressure Pot Caddy or the Pressure Pot Caddy V2 and have time to use it for a while. I was hoping I could get some feed back on it from those that have used it.
Just some questions off the top of my head,
1. How do you like it?
2. What happen to it if you had a resin spill?
3. Value for the money?
4. Too many holes in the V2?
5. Any other suggestions you can make or issues you have had with it.
I am also looking at making a version out of HDPE 1/4" sheet. This would be so resins hopefully peel right off. However it would make the Caddy more expensive, about $35 each (V2 version) Would it be worth it?
It's been a while since I have been able to turn, so hopefully again soon!
Thanks for any feedback!
:biggrin: