Art Deco Ballpoint

From IAP-Wiki
Revision as of 14:37, 29 November 2010 by en>Randyrls
Jump to navigation Jump to search

General Information

Available in both ballpoint single tube and two tube roller ball and fountain pen.


Alternative Names


Bushing Sizes

The bushing sizes are documented on the instructions, but the actual measurements of the fittings and tubes are listed below.

The fittings are both 0.495"

Note: The bushings for this pen are the Majestic Squire bushings.  So if you have a set of JohnnyCNC's TBC bushings, you are set.

Tube Length(s)

 

Tube Dimensions
  Tube
I.D.
0.347"
O.D.
0.365"
Length 1.994"

 



Sources

This pen is only available at Penn State Industries


Assembly tips


Common Pitfalls

If you have to dis-assemble the nib or clip, use a transfer punch to remove the fitting.  The fitting is composed of several pieces that may separate when being driven out.  If this happens, drill a 9mm or 23/64" hole in a scrap piece of acrylic and insert the tube portion of the fitting into the hole.  Press the fitting back together.