Dale Allen
Member
I was given an old model of this tool but from what I can tell the method seems similar to the new ones.
When I look closely at my untouched drill bits, split point and other, the cutting surface looks to be ground flat and tapered so the cutting edge is raised.
When I run one through the paces on the drill doc the cut surface is rounded.
Is this the way the tool sharpens them?
Seems to me it leaves the very edge unable to do it's job.
Or maybe I'm helplessly lost with this tool!
Dale
When I look closely at my untouched drill bits, split point and other, the cutting surface looks to be ground flat and tapered so the cutting edge is raised.
When I run one through the paces on the drill doc the cut surface is rounded.
Is this the way the tool sharpens them?
Seems to me it leaves the very edge unable to do it's job.
Or maybe I'm helplessly lost with this tool!
Dale