peppermill

Here is a little something different. I have to admit it was fun not having to worry about thin walls. Feel free to leave comments, I am always looking for feedback. Thanks, Ray

Been in Christmas gift mode lately and whilst I have been restocking my ravaged pen supplies, I decided to try my hand at a Pepper Grinder. I also thought I'd give some Seam Rippers a go. They have proved rather popular. A mix of the ones with the stupid spring arrangement and some I...

Hi, I am trying my hand at turning peppermills and have used two different processes but get the same (Bad) results!! 1. Turn the entire blank and mark it with tenon, base, tenon, spigot, top, tenon. Turn down tenons, and part off. Mount base and drill 1 5/8" and then 1 1/16 holes...

Hi, I've been lurking these forums for a while now. I turn pens and bottle stoppers and such every now and then. I finally have a project that I'm proud to show off to you folks. My first set of spice grinders - salt and peppermills. I used the Crushgrind ceramic mechanisms with shafts. Mills...

I bought two Pepper mill kits from Woodcraft, I thought 2 inch stock would be big enough but these take a 1-3/4 hole in the bottom and to me this doesn't seem like a lot of stock left on the outside, the kit is the Ceramic Crush Grind Shaft Pepper Mill. any one know of one that will work better...

Here is a 10" peppermill made from a free piece of mahogany. It is finished with WOP. This peppermill #3 for me. Comments welcome