laser inlay

I wanted to see if I could use the laser engraver to segment acrylic, so I picked Syracuse's logo in blue and organge from PSI. I drilled them out, turned them round, then cut out an S from the orange blank. I then offset my image by .007 to account for the material the laser would remove and...

The odd things you come up with when you mix together different parts of the hobby. This was my first attempt to cast a pen blank that I had cut with a laser. I just used silmar 41 and coastal scents orange glitter. I did the casting upright in a pill bottle. I should have used my sierra mould...

I made this from a Navy Blue blank purchased from The Village Workshop and a piece of Yellowheart from a lumber supply place in Seattle. It took a bit of trial and error to get the engraving to the right depth so I didn't turn/sand off the engraved lines when I assembled it for final turning and...