PTownSubbie
Member
I have searched high and low and am working on a list of Tap/Die sizes used in various kitless designs for FP Nib feeds and Front Ends.
This is what I have so far. Feel free to add to it with your experiences or contradict what I have written. There is no consolidated list anywhere that I can find.
Lets try to make this thread that consolidated list.....
Thanks!
Fred
Tap Size - Drill Hole - Compatability
M6.4x.5 - "C" - Schmidt Roller/Small Heritance/Small FP feeds
M8.4x.75 - "O" - Large FP feeds
M7.4x.5 - "J" - Meisternibs
M8.4x1 - "O" - Baron/Sedona/Navigator Front Ends
M8.5x1 - - Sierra Transmission
This is what I have so far. Feel free to add to it with your experiences or contradict what I have written. There is no consolidated list anywhere that I can find.
Lets try to make this thread that consolidated list.....
Thanks!
Fred
Tap Size - Drill Hole - Compatability
M6.4x.5 - "C" - Schmidt Roller/Small Heritance/Small FP feeds
M8.4x.75 - "O" - Large FP feeds
M7.4x.5 - "J" - Meisternibs
M8.4x1 - "O" - Baron/Sedona/Navigator Front Ends
M8.5x1 - - Sierra Transmission
Last edited: