Buzzzz4
Member
I did some casting of pine cones I was sent. These were cast in Alumilite and finished with CA on Streamlines. A couple were drilled off center for a different kind of look. No bubbles during the turning which was the very good to see. Comments or suggestions are appreciated. Thanks!
![184132_10150139766820692_142460600691_8696668_5042478_n.jpg](/proxy.php?image=https%3A%2F%2Fa1.sphotos.ak.fbcdn.net%2Fhphotos-ak-snc6%2F184132_10150139766820692_142460600691_8696668_5042478_n.jpg&hash=eea99bc00b0d32787aa5130611c6d776)
![184876_10150139766880692_142460600691_8696670_6900070_n.jpg](/proxy.php?image=https%3A%2F%2Fa4.sphotos.ak.fbcdn.net%2Fhphotos-ak-snc6%2F184876_10150139766880692_142460600691_8696670_6900070_n.jpg&hash=d9f602b3598e1627a875d3f3ff3033ca)
![180720_10150139767000692_142460600691_8696673_8329617_n.jpg](/proxy.php?image=https%3A%2F%2Fa2.sphotos.ak.fbcdn.net%2Fhphotos-ak-snc6%2F180720_10150139767000692_142460600691_8696673_8329617_n.jpg&hash=9d3ec09be60649212e4ec07d185f4479)
![182824_10150139767140692_142460600691_8696674_3398088_n.jpg](/proxy.php?image=https%3A%2F%2Fa3.sphotos.ak.fbcdn.net%2Fhphotos-ak-snc6%2F182824_10150139767140692_142460600691_8696674_3398088_n.jpg&hash=3bdaed0300276660efde83961f6b82cc)
![183732_10150139766930692_142460600691_8696671_2484464_n.jpg](/proxy.php?image=https%3A%2F%2Fa6.sphotos.ak.fbcdn.net%2Fhphotos-ak-snc6%2F183732_10150139766930692_142460600691_8696671_2484464_n.jpg&hash=cedf9b1b4d2e40d7a17f6893e285f882)
Last edited: