VERTEX problem -- need help!

Signed-In Members Don't See This Ad
Mack C.

Mack C.

Passed Away Sep 29, 2018
In Memoriam
Joined
May 4, 2008
Messages
2,019
Location
Brooklin, ON Canada
Is there any way to remove the click/clip assembly without damaging the plastic tranny. Somehow my tube was 1 - 2 mm's short leaving the cartridge to protrude that amount.

I was certain I would damage the plastic tranny, but I went ahead and attempted to remove the clip assembly anyway. Yup, I damaged the tranny and consequently have an entire Blk. Ti. Vertex assembly minus a tranny which I'm sure I'll not be able to replace.

I would be most appreciative of any and all advice you can offer!
 
Signed-In Members Don't See This Ad
I replaced a faulty trans using an old Parker pen I had. Easier (like mentioned) is probably calling PSI. They have always been extremely quick with replacement parts.
 
Mack,
You could send it to me, then I would have two of them. Been there, done that. Will figure out how to fix it later.
 
You must log in or register to reply here.
Back
Top Bottom