Here's a translation of that German page on making rings:
The URL is very long, so i'll let you find it in the other post...
Hello Forum
For rings I use waste wood, e.g. the corners of cut bowl blanks, and cut wafers on the band saw.
Drill a hole according to your ring size
Polish the inside with an old drill and steel wool - which is fastened to the drill with hot melt glue
Rough cut the blanks on the bandsaw
This is my chuck for three ring sizes (16/18/20mm)
Attach blank with wedge cut from PVC. Turn, (?) buff, oil (if necessary, change blank in order to reach both sides up to the interior edge)
Lots of fun
Cheers, Steven
Hope that helps! I didn't put the German down here, but you can figure out what goes with each picture, I'm sure!
Andrew
The URL is very long, so i'll let you find it in the other post...
Hello Forum
For rings I use waste wood, e.g. the corners of cut bowl blanks, and cut wafers on the band saw.
Drill a hole according to your ring size
Polish the inside with an old drill and steel wool - which is fastened to the drill with hot melt glue
Rough cut the blanks on the bandsaw
This is my chuck for three ring sizes (16/18/20mm)
Attach blank with wedge cut from PVC. Turn, (?) buff, oil (if necessary, change blank in order to reach both sides up to the interior edge)
Lots of fun
Cheers, Steven
Hope that helps! I didn't put the German down here, but you can figure out what goes with each picture, I'm sure!
Andrew
]