Stopper with coin cast in PR

[armyturner]

Here is my first attempt at casting a coin in PR. I think there was a little air trapped under the coin and the pressure forced it out as the PR was curing. You can see the imperfection in the lower right portion of the stopper in the first pic.

 

[Tubby]

Jeremy,

That looks like it is in the clear portion of your resin....if so you can recast that spot, under pressure again, and let the resin cure. Then take it out and re-turn it. It is usually alot easier if it is in blank form (I.E. not turned yet) but you may want to try it.

I have had that happen before, and it turned out just fine with little to no noticeable effect.

Ed Jordan
Wichita Falls, TX

 

[hanau]

looks good, i sent you an email