sschering
Member
This is a vase I made for a Secret Santa exchange.
It's my first shot at hollowing and working with carbide tools.
It's not as hollow as I'd like but I did what I could with the tools I had.
One thing is for sure. If I do more of this I'll need some proper hollowing tools.
There is only so much you can do with an EZ Turn finisher.
Finish is Tru-Oil. It may get a few more coats before it gets gifted.
The block was 5" x 5" x 6"
It's my first shot at hollowing and working with carbide tools.
It's not as hollow as I'd like but I did what I could with the tools I had.
One thing is for sure. If I do more of this I'll need some proper hollowing tools.
There is only so much you can do with an EZ Turn finisher.
Finish is Tru-Oil. It may get a few more coats before it gets gifted.
The block was 5" x 5" x 6"
