Russianwolf
Member
Okay, replaced the mixer shaft with a small brass rod of the smae diameter, Cut off the paint pickup tube and built a rack to hold my molds. Cast a couple test blanks yesterday. One set with very tight fitting delrin plugs came out fine, a set with not quite as tight a fit, the resin was pushed into the tubes. Charge the pot to 60psi and it held fine.
I'm trying again today using both delrin plugs and my resin saver mold. I filled both sets of tubes with Polymer Clay (what I had on hand) to keep the resin incursion to a minimum. Charged the pot to 55psi.
results coming latter.
I'm trying again today using both delrin plugs and my resin saver mold. I filled both sets of tubes with Polymer Clay (what I had on hand) to keep the resin incursion to a minimum. Charged the pot to 55psi.
results coming latter.