Woodnick43
Member
Does anyone have any experience with the Axminster eccentric chuck sold by craft supply?. If so, could you relate some things you have made on it and how you like it ?
Thanks for your help.
Thanks for your help.
Opinion needed
- Thread starter Woodnick43
- Start date
Signed-In Members Don't See This Ad
PenPal
Member
I have enough trouble turning normal mate eccentric at 80 yes goodday mate.
Peter.
Peter.
KenV
Member
Axminister Exccentric Chuck
I have one of those -- Use it for making buttons for the knitter/spinner/weaver that I live with. Also used for putting decorative fills into the bottoms of plates/platters and similar. I cut the button holes with a tiny gouge as a rule, but could use a drill.
Well made, and has very little supporting materials on use. Bill Bowers shows a platter with it in his book on spirals, but there is not enough there to make the purchase a good value.
John Giem did a YouTube video on a similar use - but used a shop built jig instead of the Axminister.
I have one of those -- Use it for making buttons for the knitter/spinner/weaver that I live with. Also used for putting decorative fills into the bottoms of plates/platters and similar. I cut the button holes with a tiny gouge as a rule, but could use a drill.
Well made, and has very little supporting materials on use. Bill Bowers shows a platter with it in his book on spirals, but there is not enough there to make the purchase a good value.
John Giem did a YouTube video on a similar use - but used a shop built jig instead of the Axminister.