vtgaryw
Member
I've had my 1mW NEJE for 2 years now with no problem. I was just engraving a pen box in three steps. I did the left image, moved the box over, did the center image, moved the box over, and when I moved it to do the right image, the problem started.
After doing a carving preview, the table moves so the laser is almost 1/2" below the middle of the image (i.e., does not return to the center of what it just did the carving preview for.)
I've tried all sorts of combinations of rebooting, reloading, powering up/down, etc, but it still does the same.
Anyone have any ideas?
Thanks,
Gary
After doing a carving preview, the table moves so the laser is almost 1/2" below the middle of the image (i.e., does not return to the center of what it just did the carving preview for.)
I've tried all sorts of combinations of rebooting, reloading, powering up/down, etc, but it still does the same.
Anyone have any ideas?
Thanks,
Gary
