Dale Allen
Member
I've used this a dozen times since it was finally finished so it is now about time I made it better looking with some paint and stain.
I sized the table so that a full 4" board at 45 degree angle is still against the front 4" of the disc and the miter gauge is fully in the track.
The suction is so good it held the top on without the clamps. Used an old 2" floor attachment, turned an adapter out of PVC and used a 45 ell from the shop vac set. The white wire cage is a piece of wire shelving.
I sized the table so that a full 4" board at 45 degree angle is still against the front 4" of the disc and the miter gauge is fully in the track.
The suction is so good it held the top on without the clamps. Used an old 2" floor attachment, turned an adapter out of PVC and used a 45 ell from the shop vac set. The white wire cage is a piece of wire shelving.