White dots......

[AceMrFixIt]

Poured some blue blanks, don't have a pressure pot.... After final sanding white dots appeared in the small bubbles in the blank. Any tips to remove them? Tooth brush and water helps a bit. But she got mad cause I used hers...................

 

[Pen Maker]

Dremel ?

 

[AceMrFixIt]

I should say, the pits from the bubbles have sanding dust in them........ Got a good shine. Don't want to damage what I have, just get the dust out.

 

[Pen Maker]

since they're plastic, why not just water and compressed air?

 

[AceMrFixIt]

Tried soaking them in water, but didn't try the air. Worth a shot. Thanks

 

[Pen Maker]

This should be posted in Casting section.. I'm just an idiot here, Someone will have a realistic idea. There is a lot of guy's doing this so someone will have a solution and recommendation. Best of Luck ! Your ahead of me here.

 

[1080Wayne]

Rick The dust may be well enough packed in that compressed air won`t remove it . Then you are reduced to using a fine needle - she may get mad again . Best to fill in those holes with medium CA before sanding . Wayne