Rocklery Inlace material, what finish?

[arw01]

Do you guys just polish it up with MM and then wax it?

I'd like to put CA on it, but I always have to sand off the CA when I don't use some BLO with it.

Should I just get some rattle can lacquer?

 

[ed4copies]

I have not used "Rocklery Inlace", however, the term inlace is usually used to describe a polyresin (has a "drip add" hardener and a smelly base material).

Polyresin NEEDS no finish, but you can use CA to fill, if you like.

Best answer (IMO) is to buff with tripoli and white diamond, after sanding to 1000-2000 grit.

LOTS of other opinions, so you can't be WRONG, just mis-directed!!!

 

[arw01]

That had a typo in it!

Thanks Ed. I did not notice I mis-typed ROCKLER in the title.

I may have to invest in a buffing set up them. I have an old 1/3 HP motor that could be used for such a little beastie. Maybe with one of those triple buff setups so I could just move along quickly.