Help!!! - delrin bushing stuck in pen

[THarvey]

Leave it to me to do what others said cannot be done.

I was working on finishing a sierra pen with CA, using my new bushing from Johnycnc. Well my delrin bushings are glued to my pen blank.

How do I break them free without destroying the pen or the bushings.

Thanks

Tim

 

[DozerMite]

You can't twist them? They should come loose if they will twist.

 

[johnnycnc]

Bushings use instructions, this should help.
http://docs.google.com/Doc?id=dhcz5nnk_2cbgf9q

There is a section on delrin use.
This is linked on my site, btw.

 

[THarvey]

You can't twist them? They should come loose if they will twist.

I have not been able to twist them yet. I did try turning off some of the glue.

It is not very thick. Only five coats of thin CA.

I set it aside for now. I will try again.

Thanks.

 

[THarvey]

Bushings use instructions, this should help.
http://docs.google.com/Doc?id=dhcz5nnk_2cbgf9q

There is a section on delrin use.
This is linked on my site, btw.

Thanks John.

"When all else fails, read the instructions."

That did it. I was concerned that using pliers might damage the bushing. Thanks for the help.