cutting blanks

[Dale Parrott]

I'm hoping some one can help me out here. I'm looking for the thread where someone was explaining cutting pen blanks on the diagonal to get 2 pens from one blank. It might have been with a polymer clay blank.
Thanks in advance...
Dale

 

[Gregf]

I think this is the thread.

http://www.penturners.org/forum/f14...king-slimlines-out-tru-stone-m3-metal-115642/

There wasn't any details of how to do this.

 

[Dale Parrott]

Thank you!

 

[ctubbs]

Dale, I think there is an article in the Library about this but I was unable to find it. I seem to remember there being a 'V' grove device to hold the blank on edge to be cut on the bias, but I have been asleep since then.
Charles