My brother bought a mill and had it converted to cnc.
He has been teaching me a little about it, but I mostly just load it and push the go button.
I was cutting out some Corian cutting boards and on the last one, I popped it out of the fixture and the edge peeled the skin off of the side of my thumb, about an inch or more long and deep enough to leave a obvious divot. It just stopped bleeding a little bit ago.
The edges of these are like a razor after being cut. I will wear some gloves when removing them from the fixture from now on.
Be careful using pens made from Corian... you could loose a finger. :biggrin: Just kidding of course.
He has been teaching me a little about it, but I mostly just load it and push the go button.
I was cutting out some Corian cutting boards and on the last one, I popped it out of the fixture and the edge peeled the skin off of the side of my thumb, about an inch or more long and deep enough to leave a obvious divot. It just stopped bleeding a little bit ago.
The edges of these are like a razor after being cut. I will wear some gloves when removing them from the fixture from now on.
Be careful using pens made from Corian... you could loose a finger. :biggrin: Just kidding of course.