LF Turnkey Pressure Pot with wooden tray

Signed-In Members Don't See This Ad

Flush1974

Member
Joined
Jan 10, 2013
Messages
79
Location
St Petersburg, Florida USA
I would like to start casting my own resin but don't have time to run around and collect the parts and build the MDF tray. Does anyone have an extra one they are willing to sell?

Thanks,
Steve
 
Signed-In Members Don't See This Ad

Edgar

New Member Advocate
Staff member
Joined
Feb 6, 2013
Messages
6,890
Location
Alvin, TX 77511
A tray isn't absolutely necessary if you can't readily find one and don't want to take the time to build one.

I just placed a scrap piece of plywood in the bottom of the tank to provide a flat surface & used an elbow fitting on the inside of the lid so the air doesn't blow directly down onto the resin. I don't do a lot of casting, so I just do one mold at a time and set it directly onto the bottom board. I'll take the time to build a tray if I ever want to do more than one mold at a time.
 

CrashmanS

Member
Joined
Nov 21, 2015
Messages
91
Location
West Virginia
I had my local votech laser cut a few 1/4 wood circles and just lay it I the bottom. Not as hard as you would think.

c3a14dfde3fbfc77d4d9a1a4df7b57bf.jpg

afb4c8394aff818de3802890db922f43.jpg


Sent from my SM-N920P using Tapatalk
 
Top Bottom