I am sure that I am not describing this correctly.
I use EWT (all 3), the shortest ones. I found an inexpensive source for the square and square radius carbide inserts. However, I can't find a source to replace the EWT round/finishing cutters. I was hoping to pay someone to make me a tool (handle and steel shank/wand) that will accommodate the non-proprietary round carbide cutters. As you know, the EWT and the like go for $16; I have seem similar for $4 to $7 each.
Thanks for reading and bearing with my ignorance of the terminology.
I do not have any interest in learning how to build one myself.
I use EWT (all 3), the shortest ones. I found an inexpensive source for the square and square radius carbide inserts. However, I can't find a source to replace the EWT round/finishing cutters. I was hoping to pay someone to make me a tool (handle and steel shank/wand) that will accommodate the non-proprietary round carbide cutters. As you know, the EWT and the like go for $16; I have seem similar for $4 to $7 each.
Thanks for reading and bearing with my ignorance of the terminology.
I do not have any interest in learning how to build one myself.