what are my options

Signed-In Members Don't See This Ad

markgum

Member
Joined
Apr 8, 2008
Messages
3,825
Location
Keenesburg, CO
so to many pen instructions on the table, and reading the instructions for a Statesman drilled the blanks and then when I put the tubes in the holes were to large. Said a bunch of potty mouth words looked and realized I had a Jr. Statesman kit. said even more potty mouth words. If it wasn't a expensive blank I would toss it. but would like to try and save it.
I'm thinking of sweaping up the shavings from drilling and pushing them in and soak it in CA. Or are the tubes for a Statesman and Jr. Statesman the same length?
any other thoughts?
 

johnnycnc

Member
Joined
Feb 27, 2006
Messages
3,612
Location
columbus, IN, USA.
Tubes are not the same length.Statesman lower is especially longer.
Hole for Statesman upper will pretty much be the finished blank size for Jr. upper.Lower is not far behind.I don't see the filler looking good.
How about adding length to the blanks if needed with oops band(s)
and getting the full size kit?
There may be better solutions, but those are my thoughts!:biggrin:
 
Top Bottom