cdcarter
Member
I was about to turn a round top last night using the 3b bushings from Bear Tooth, but the instructions call for a .471 bushing, which wasn't in the set. (I'm going by memory on the numbers, so be gentle!) That size would match the hardware.
Instead, I had two that were about .55. One was wider than the other. Anybody know if maybe I got a buggered set or is there something I'm missing?
I think there's a .471 bushing for that mandrel in my perfect fit set, but I hate mixing them up. Not organized enough to get them all back in the right set.
I tried to get Ernie, but he wasn't answering. I've emailed him, but maybe somebody here knows too.
Carl
Instead, I had two that were about .55. One was wider than the other. Anybody know if maybe I got a buggered set or is there something I'm missing?
I think there's a .471 bushing for that mandrel in my perfect fit set, but I hate mixing them up. Not organized enough to get them all back in the right set.
I tried to get Ernie, but he wasn't answering. I've emailed him, but maybe somebody here knows too.
Carl