redfishsc
Member
Thus far, getting that original clip back onto the Pentel has been the biggest headache. I'm having a hard time doing it without marring the finish.
How are you guys doing it?
How are you guys doing it?
Putting the clip back onto a Pentel...???
- Thread starter redfishsc
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Chuck Key
Member
See photo half way down the first page at this link:
http://162.42.234.18/forum/topic.asp?ARCHIVE=true&TOPIC_ID=25923&whichpage=1&SearchTerms=clip
Chuckie
jthompson1995
Member
I flip it upside down on the originalpentel sleeve, then line up the ends and slide it on to the new from the old. Similar to what Chuckie does, but I don't have a special tool for it.
redfishsc
Member
10-4---- I like the tool that's used. I may try to modify it so that it laps over the top part, but then again it may stretch the clip too much.
Darley
Member
I did myself an inserting tube tool with corian and use it to widening ( open it up ) the pentel pencil clip to fit the pen barrel
scotirish
Member
Slide s plastic straw from the bottom on the pencil, stopping just short of where you want the clip. Slide the clip over the straw till it comes off on the wood. Slide the straw off!
woody0207
Member
What a great idea. Can't wait to try this. The darn clip has been a challenge.
redfishsc
Member
I don't have a straw handy, but I'm fairly sure the Pentels I tend to make are too fat for a straw, lol.