Cannonball
Member
Has anyone tried the liquid friction polish and sealer from PSI. says it is lacquer based and dries instantly on the lathe. Always looking for an alternative to CA
PSI liquid friction polish and sealer
- Thread starter Cannonball
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
monophoto
Member
I've used it. It's easy to apply, and holds up reasonably well. It does build, but not nearly as plasticky as CA.
It's basically lacquer that has been thinned - if you like the result, you can probably make your own at a significantly lower cost.
It's basically lacquer that has been thinned - if you like the result, you can probably make your own at a significantly lower cost.
raar25
Member
Use it all the time. It is my go to finish on everything except high end pens and stabilized.
Epoxy or a UV finish .
Both come with a learning curve and you need to be able to rotate at 50 rpm.
With epoxy I am rotating the project for 5 to 7 days non stop ...
I am not trying to be sarcastic, but normally I try never plan on making anything plain or low end .
I leave that to china ..
Both come with a learning curve and you need to be able to rotate at 50 rpm.
With epoxy I am rotating the project for 5 to 7 days non stop ...
I am not trying to be sarcastic, but normally I try never plan on making anything plain or low end .
I leave that to china ..
Wright
Member
Been using CA for finish for years with excellent results.