wizical
Member
hey everyone,
I ran into a bit of trouble with my lathe today, I turned it on, then it shut off.
it said on the readout, "Hardware Fault"
and also on the LCD it said "Low Voltage"
I dont know what caused this to occur. I want to know if anyone else has ran into this sort of problem and what steps were taken to fix it. thanks
I ran into a bit of trouble with my lathe today, I turned it on, then it shut off.
it said on the readout, "Hardware Fault"
and also on the LCD it said "Low Voltage"
I dont know what caused this to occur. I want to know if anyone else has ran into this sort of problem and what steps were taken to fix it. thanks