Need dimensions for bushings

[Ted Evans]

Hello All,

I am in need of the bushing dimensions for a Flat Top Push Pen (Berea #4160/JB) and also, a Designer Filigree (PKMONTFLR) from PSI. If any one would be willing to share this information, I would be most appreciative. I have found that I have better luck when I make my own bushings. Any help/suggestions would be appreciated.

Bear

 

[johnnycnc]

Bear, if you have the kits and you are going to make your own, then
surely you must have calipers or something to measure with.
Just measure the fittings on the kits, and the inside of the tubes, and away you go!

 

[Ted Evans]

Hello John,

That is what I do with the other kits that I have done, however, these two are different because of the mid section and I have not been able to resolve the questions in my mind.

Thanks for the suggestion.

Bear

 

[Ted Evans]

Tim from Wood N Whimsies supplied the dimensions for the PSI kit, thanks Tim, however, I am still in need of the dimensions for the kit from Berea.

Thanks.

Bear