I am about to turn the Raven (Laserlinez...beautiful hardware). I have not
found the hardware to match the Jr Gent II bushing dimensions or the bushing
that came with my kit. I bought 4 but only measured one so far. This isn't
anything other than some encouragement to measure your hardware before relying
on the bushings of the JrII or the free ones. It may just be me and I have
informed Constant.
As we all know, but I seldom do, it's a good practice to measure bushings and
components anyway. Again, this is just my comparison to two sets of bushings
(TBC and CSUSA mandrel bushings) to ONLY 1 kit. Just something to look out for.
I will let you know how it turns out.
I just spoke to Constant. The bushing he sent me are fine. They were not/never supposed to be Jr Gent II bushings.
According to Constant (just got off the phone with him), the hardware meets the material at a slight radius.
My sincerest apologies if I caused any one concern. I am going to use his bushings.
Last edited: