mikes pens
Member
I am curious what some of you do with the Mont Blanc Pen Cap and clip. Do you add a drop of glue into the cap nut so the clip doesn't move and the cap doesn't unscrew?
Mike
Mike
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Mont Blanc Pen Caps
- Thread starter mikes pens
- Start date
Signed-In Members Don't See This Ad
- Status
- Not open for further replies.
Signed-In Members Don't See This Ad
jkirkb94
Member
Mike, I just twist the cap on tight. I don't see anything wrong with adding a drop of CA to the screws. As a whole I don't carry or use my pens on a constant basis so I don't know if there is a problem with the caps/clips loosening. Have you noticed a problem? Kirk[8D]
mikes pens
Member
I find that sometimes they loosen and then the clip could spin and damage the wood on the upper barrel. I sometimes use glue and sometimes don't.
Mike
Mike
dougle40
Member
Mike ,
I make a lot of Mont Blanc pens and I've never glued a cap on yet and even the one that I use every day has never come loose .
I make a lot of Mont Blanc pens and I've never glued a cap on yet and even the one that I use every day has never come loose .
Mike...I use Lok-tite from Home Depot. It makes the pen difficult but not impossible to take off. I find it has a million useful purposes around the house.
dougle40
Member
Lok-tite would be one method but make sure that you buy the removable type . Some of the lok-tites are permanant and it takes heat to remove something which is something we can't do with a wood pen .
- Status
- Not open for further replies.