Hi folks. Almost all of us have had problems at one time or another with fittings on our kits. What would you think of sending a letter from our B.D. (Benevolent Dictator) Jeff asking that they include the measurements/tolerances of the portions of the kits where the pressure fittings fit. We know we can't trust the bushings, but maybe we can trust a set of verniers or a micrometer. Or do you think the variance between each kit of the same style is too great? It sure gets tiresome measuring each component each time.
Letters to our suppliers?
- Thread starter DCBluesman
- Start date
Signed-In Members Don't See This Ad
- Status
jwoodwright
Member
Lou,
That is a great idea. [
]
That is a great idea. [
]
G
Guest
Guest
That's a little too anal for me.
Sure I mant a good fit but Measureing each one is just a little too much for me.
I match up a bushing with the component on the first pen of any kit I do.
After that the bushings are pretty much a guide line.
If I can't feel the transition it's a good fit.
Lou you've seen my work in person,how were the fits?
Sure I mant a good fit but Measureing each one is just a little too much for me.
I match up a bushing with the component on the first pen of any kit I do.
After that the bushings are pretty much a guide line.
If I can't feel the transition it's a good fit.
Lou you've seen my work in person,how were the fits?
Your fits are excellent, Eagle. I've told you that in person. But not all of us have your gift...I seem to remember telling you that as well! []
]- Status