HFT Epoxy Question

[MartinPens]

Does anyone know if this stuff has the same effect as CA in terms of needing to "air out" prior to proximity to metal components??
I'm needing to get products out the door as quick as possible, but if I use CA, i risk the components fogging and being damaged.

I'm conducting an experiment, but thought I would ask in case it's been done already.

Thanks!

Regards





Sent from my iPad using Forum Runner

 

[hewunch]

Never had a problem with off gassing of hft epoxy. I use it all the time.

 

[MartinPens]

Sweet!! Good bye CA!

 

[hewunch]

Now that said, I would give it an hour or so to really cure especially in a low air flow area.