jbyrd24
Member
Hi all
Posted this in another forum but couldn't get a response.
Thought maybe I posted in the wrong forum. I realize this
sounds like an absolutely stupid question, but I can't pull
the barrels apart even with rubber gloves on.
The kit I'm working on is a Hut Euroclassic Pen.
My problem is when assembling I didn't line up the grain
correctly. I would like to pull apart the upper and lower
barrels without damaging the tulipwood. The problem is the
tubes are very tight and the same dimension joined by the coupler ring. Any suggestions would be greatly appreciated.
Thanks
Bryan (Jake's Dad)[:I]
Posted this in another forum but couldn't get a response.
Thought maybe I posted in the wrong forum. I realize this
sounds like an absolutely stupid question, but I can't pull
the barrels apart even with rubber gloves on.
The kit I'm working on is a Hut Euroclassic Pen.
My problem is when assembling I didn't line up the grain
correctly. I would like to pull apart the upper and lower
barrels without damaging the tulipwood. The problem is the
tubes are very tight and the same dimension joined by the coupler ring. Any suggestions would be greatly appreciated.
Thanks
Bryan (Jake's Dad)[:I]