Grizz press

Signed-In Members Don't See This Ad
Status
Not open for further replies.
G

Guest

Guest
Finally got aroune to adapting it.I had considered a turret but that would have meant offseting the ram and I didn't want to do that.
I had some high density cutting board stuff laying around.
I stacked it and glued with thin CA.
The only pressure exerted is down so I think it will hold fine.
Future plans are to add a post for disassembly.
I do not plan on using the depth stop.I make too many modified pens for that to work.
The "steps" are in one inch increments.





Image Insert:
2004918115234_DCP_1148.jpg

57.35KB

Image Insert:
2004918115437_DCP_1149.jpg

56.03KB

Image Insert:
2004918115516_DCP_1150.jpg

55.83KB
 
Status
Not open for further replies.
Top Bottom